* *

Picture Bit

            

Welcome, Guest. Please login or register.
Did you miss your activation email?
December 23, 2024, 06:11:41 am

Login with username, password and session length

Members
Stats
  • Total Posts: 32006
  • Total Topics: 3964
  • Online Today: 126
  • Online Ever: 235
  • (December 09, 2019, 06:27:14 pm)
Users Online
Users: 0
Guests: 175
Total: 175
175 Guests, 0 Users

Author Topic: Rebuiling Girvin Vector II fork,  (Read 2908 times)

royboycv

  • Novice
  • *
  • Posts: 38
  • Karma: 0
Rebuiling Girvin Vector II fork,
« on: February 21, 2013, 10:40:25 am »
Hi all ,just found this site after buying a Vector II fork ,and yes pushing the price up even higher.
One down side i can see of the fork, is the price of even the smallest part ,so the big question is , does any body know what are dimentions of the small plastic thrust washers ,(part number 27 ,SEAL SPACER ,EXTREME SEAL 14 off) and what material it should be. Is it Nylatron?
I have found them on e-bay £10  or so ,but £35 post ?? Must be able to make them for less than this.

Can anyone advise  !!!!!!!!!!!!
                                      Its late ,but does no one in the U.K. want to keep the cost of running these FORKS down ?????? Lets make some parts to keep these things going .!!!!!!!!!!!!
« Last Edit: February 22, 2013, 03:06:58 pm by royboycv »
Life too short for sleeping ,get off your arse and ride.

Colin

  • Guru
  • *****
  • Posts: 1244
  • Karma: 14
  • in a village near Northampton, UK
Re: Rebuiling Girvin Vector II fork,
« Reply #1 on: February 22, 2013, 01:43:42 am »
if the seller of the kits is in the USA and you're in the UK, contact them for a postage price and I think they'll do it a lot cheaper.
Anything less than about £18 all in for one of these original kits is cheap.

Col
2001 OzM
2000 OzX
1999 x500
1999 900 Frame
1998 4000se
1998 4000
1997 957 Frame
1997 857 Frames
1997 XP-X (856)
1995/6 x55/x56 Frame
1992 962 Frame
1991 Marin Pine Mountain with a Flex Stem