Welcome to the new and improved Proflex / K2 Tech Forum!
Orange, I need your help. How do I remove the ODS shaft from the Girvin strut? It's been long enough since I put it together that I don't recall how it went together and I haven't found a good diagram or set of instructions. None came with my parts. Is the shaft end threaded? I don't remember it being so, but bumping the strut-shaft screw didn't dislodge it and before I gave it a more vigorous thump, I thought I'd better ask. I put a bit of Kroil down the shaft to loosen it - maybe that will help. If the shaft has a threaded end, is there a cross hole in the shaft to stop it turning? Or is there another technique? None of my non-marring jaw pliers can get through the spring to grip the shaft. I'm looking forward to anyone's response on this. Thanks. Ed.