Author Topic: Rear pivot bushing instalation (Read 5049 times)

spikebender · « **on:** May 12, 2018, 03:34:52 pm »

Hello group, I'm finally getting around to replacing the rear pivot bushings on my 855. Dose any have any tips on how to keep the larger o-rings in place when sliding the swingarm into place? I'm having a problem with the o-ring not staying in the groove and stretching out where it's not between the frame and bushing any longer. I've had it on and off now several times and no luck. Any help would be greatly appreciated. Thanks, Tracy

shovelon · « **Reply #1 on:** May 14, 2018, 06:56:52 pm »

Don't know if you suceeded but in the past I have used a really thin putty knife blade between the frame and rubber x-ring with grease. Slid the swingarm right on then slide the blade out.

spikebender · « **Reply #2 on:** May 14, 2018, 11:22:22 pm »

Quote from: shovelon on May 14, 2018, 06:56:52 pm

Don't know if you suceeded but in the past I have used a really thin putty knife blade between the frame and rubber x-ring with grease. Slid the swingarm right on then slide the blade out.

I like the putty knife trick. I work in a sheet metal shop. With that said the ideas are poppin.
Thanks, Tracy

Colin · « **Reply #3 on:** May 24, 2018, 07:31:12 am »

also, you can (carefully) use a "spreader" bolt,
i.e. a bolt or threaded bar just a bit under length of the width of the swing arm and then use a nut on the end of it to increase the length and thus spread the swing arm.
BUT, be very careful! only spread it a fraction, enough to get over the O or X seals!

Col.

News:

Menu

Search

Picture Bit

User

Stats

Members

Stats

Users Online

Online

Author Topic: Rear pivot bushing instalation (Read 5049 times)

spikebender

Rear pivot bushing instalation

shovelon

Re: Rear pivot bushing instalation

spikebender

Re: Rear pivot bushing instalation

Colin

Re: Rear pivot bushing instalation