K2 / Proflex Riders Group

General => Tech Forum => Topic started by: Ricky on June 07, 2004, 10:21:05 am

Title: Can you fit a 44T Crank on a 856?
Post by: Ricky on June 07, 2004, 10:21:05 am

So can you fit a 44T crank on a 856? I dont think it will work cause of the front gear, u cant move it any higher, what you guys think?

Title: Re: Can you fit a 44T Crank on a 856?
Post by: tmaybee on June 07, 2004, 12:53:17 pm

I have a 46T on my 856, but it probably depends on the size of frame you have.  Mine is an 18".


(http://idriders.com/proflex/galleries/tmaybee/my_856_Drive.JPG)

I was going to try to fit a 48T on there by shaving down the deraileur clamp, but I think I am going to use an 11-30 rear cassette.

By using larger front chainrings, you move the chainline up and make the bike more active.

Trevor    ;)

Title: Re: Can you fit a 44T Crank on a 856?
Post by: pharph on June 24, 2004, 04:33:45 am

I have a 20" 856 with a 44T and no problem.  I've seen a 44T on a 16" frame too if it helps.  I think you'd be fine with the 44T.