whitewolfairsmithing undercocking kit

[masenman]

If I purchase a wwa undercocking kit, will it get in the way if I also purchase a deadlywind barrel

[greenmtn]

I wouldn't think so.  The deadly wind barrels have a smaller OD than the stock CCI barrels, even at the base IIRC.

[super_stanchy]

the deadlywind only work with undercocking....

as far as i know, there is not a single UC kit it does not work with.

they only do not work with the stock handles/overcockers because they rub the barrel and can cause the fibers to wear

[Orgrown76]

the deadlywind only work with undercocking....

as far as i know, there is not a single UC kit it does not work with.

they only do not work with the stock handles/overcockers because they rub the barrel and can cause the fibers to wear

This man knows his shyte... Listen to him.!.!.!

[rolondo]

It works just fine. 

[cliffords the man]

I know when the deadly wind came out,
They said you had to use an UC kit for it to work
I dont ?
Its worked fine with the standard cocking arm 

[super_stanchy]

I know when the deadly wind came out,
They said you had to use an UC kit for it to work
I dont ?
Its worked fine with the standard cocking arm 

they never said it wouldnt work with the stock handle, they just said its not good for the barrel... you tear the fibres and your SOL

[jhyan]

I have a sterling with a deadlywind fibur. It has a regular sterling pump. I put a piece of shrink tubing over the area where the pump rubs, and it has worked perfect. I thought it might have a rougher pump stroke, but in fact it's actually smoother. I imagine the same thing would work with a deadlywind on a phantom.