Sniper/'Cocker Help.

[pmicka]

Hello all, it's about time I started posting again.

Let me start by saying that I am completely in the dark when it comes to Autocockers/Snipers. I bought this during the summer and never got around to figuring out what I needed to do to get it shooting.

Here are all the parts I have at the moment. There's something in the body, but it looks like need some sort of tool to remove it (yes?) What else am I missing to get this thing working?

[SnowZone]

Well I'm more into snipers than 'cockers, so I'll give you that route.
What you'll need top to bottom:
Top tube:  bolt, bolt pin, barrel  :
Lower tube:  cocking rod, IVG, main spring, hammer (it sounds like you have a valve already), 2k (?) pump kit
Frame/reg/asa of your choice.

That is a nice start.
Good luck!

[Phantom Power]

You'll need an Autococker valve tool to get the valve out. There's a jam nut holding it in. The valve tool is like a 5/16" allen key with a hole in the end to clear the valve pin (which sticks through the jam nut).

[yuppers913]

you are also missing the trigger frame...
 

[thejayare]

^^ Beat me to it.  I was about to make a smartie-pants comments about the trigger frame too.  Oh well.  What body is that, Patrick?

[JOESPUD27]

Pat,

Check out this link.  It's very helpful.

http://www.pettypb.com/sniclone.htm

Jay